Table of Contents
Advertisement
Switch LEDs
Table 1 describe the functions of the LEDs on the Ethernet switch.
LED
System
PWR
RPS
MGMT
RJ-45 Ports
Link
1
Activity
1
FULL DUP
1
FLOW
Module Ports
STATUS
ACT
1. Use the MODE Select button to select LED display mode.
For information on troubleshooting the switch, refer to the AT-8324SX Fast
Ethernet Switch Installation Guide.
Table 1 Port and System Status LEDs
Condition
On
On
Off
On
On
Amber
Green
Flashing
On
On
On
On
Flashing
Status
Switch is receiving power.
Redundant power is on and the RPS is in the
backup or active mode.
Redundant power is off or has failed.
Agent is operational.
Port has established a valid network connec-
tion.
Valid 10 Mbps connection.
Valid 100 Mbps connection.
Port has been partitioned due to an abnormal
network condition, or manually disabled.
Traffic is passing through the port.
Port has been set to full-duplex.
Flow control enabled.
A module is installed in the slot.
Traffic is passing through the port.
AT-8324SX Quick Install Guide
7
Advertisement
Table of Contents
