Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Allied Telesis AT-8724XL
Summary of Contents for Allied Telesis AT-8724XL
- Page 1 AT-8700XL Series Switch Quick Install Guide AT-8724XL AT-8748XL...
- Page 2 AT-8700XL Series Switch Quick Install Guide Document Number C613-04042-01 REV D. Copyright © 2003-2005 Allied Telesyn International, Corp. 19800 North Creek Parkway, Suite 200, Bothell, WA 98011, USA. All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesyn.
-
Page 3: Models Covered By This Guide
AT-8700XL Series Hardware Reference Printed Models Covered By This Guide This Quick Install Guide includes information on the following models: ■ AT-8724XL 24-port 10BASE-T/100BASE-TX Advanced Fast Ethernet Switch ■ AT-8748XL 48-port 10BASE-T/100BASE-TX Advanced Fast Ethernet Switch Quick Install Guide updates can be downloaded from www.alliedtelesyn.co.nz/support/at8700xl/. -
Page 4: Selecting A Site
Selecting a Site The switch can be installed in a standard 19-inch rack or on a level surface such as a desktop or bench. When installing the switch, choose a site that: ■ Allows adequate airflow around the switch and its vents. ■... - Page 5 If the LED continues to flash or remains lit, refer to the AT-8700XL Series Hardware Reference for troubleshooting information. Figure 1: AT-8724XL front panel and rear panel with AC power inlet. Front panel Uplink Module Bays...
- Page 6 Apply DC power to the switch (for DC models) Read the Safety and Statutory Information booklet before connecting a DC power supply. A copy of this booklet is included with each switch. It is also included on the Documentation and Tools CD-ROM, or can be downloaded from www.alliedtelesyn.co.nz/support/at8700xl/ Only trained and qualified personnel should connect a DC power supply.
-
Page 7: Configuring The Switch
Quick Install Guide Figure 2: DC Power inlet terminals on an AT-8724XL. FOR CENTRALIZED DC POWER CONNECTION, INSTALL ONLY IN A RESTRICTED AREA INPUT 38-75VDC , 2A DC Power inlet The Fault LED should flash for approximately 10 seconds as the switch runs internal tests. - Page 8 Log in After the switch has booted, the log-in prompt appears. If the log-in prompt doesn’t appear, press [Enter] two or three times. When the switch boots for the first time, it automatically creates an account with manager privileges. The account has the log in name “manager” and the password is “friend”.
- Page 9 Quick Install Guide Connect the PC to the Use an Ethernet cable to connect an Ethernet card on the PC to any one of the switch ports. You can browse to the router through any VLAN, as long as you give that VLAN an IP address (see below).
-
Page 10: System Leds
System LEDs System LEDs on its front panel indicate the switch’s operational status. System LEDs Power Fault Power Supply) 1. DC models of the switches do not have an RPS connector and the RPS LED will not function. The AT-8700XL Series Hardware Reference has further troubleshooting information, including information on Switch Port and Uplink Module LEDs.
Need help?
Do you have a question about the AT-8724XL and is the answer not in the manual?
Questions and answers