Falcon SSG1.5KRM-1 Owner's Operating Manual page 34

Upon the UPS sounding a continious alarm condition, the alarm status bit will be displayed on the
LCD display located on the UPS front panel. Please note the status bit number displayed and con-
tact the Falcon service department immedately. To assist please inform them of the bit(s) displayed.
Warning: Upon experiancing errors Bit, 0, Bit 1, Bit, 2, Bit 3, Bit 6 and Bit 7 errors the UPS
must be immediately turned off and the Falcon service department contacted. Attempting
to turn the UPS back on may result in furter damage to its internal electronics.
UPS Alarm Status Display
BIT 0 ;DC BUS voltage over high flag
BIT 1 ;soft start fault flag
BIT 2 ;inverter voltage over high flag
BIT 3 ;inverter voltage over low flag
BIT 4 ;output current over high flag
BIT 5 ;battery voltage over high flag
BIT 6 ;low DC bus voltage flag
BIT 7 ;inverter voltage feedback error flag
34