Falcon SSG1.5KRM-1 Owner's Operating Manual page 23

Making Load Segment Settings
A. Setting load segments to automatically turn off the load segment when utility power is lost
1. Press the "Function/Test" and "Set/Alarm Silence" buttons at same time and hold
them for one second. The unit will emit one alarm beep and then enter the
Configuration Mode.
2. Press the "Function/Test" button repeatedly and move the dot to function BIT 3 (for
load segment 1), or BIT 5 (for load segment 2).
3. Press the "Set/Alarm Silence" button once to turn on (dot) Status BIT 7.
4. Press the "Set/Alarm Silence" and "Function/Test" buttons at same time again
and hold for one second. The alarm buzzer will sound one short beep to acknowledge the
UPS has stored the settings.
B. Setting load segments to automatically turn off the load segment at low battery
1. Press the "Function/Test" and "Set/Alarm Silence" buttons at same time and hold
them for one second. The unit will emit one alarm beep and then enter the
Configuration Mode.
2. Press the "Function/Test" button repeatedly and move the dot to function BIT 4 (for
load segment 1), or BIT 6 (for load segment 2).
3. Press the "Set/Alarm Silence" button once to turn on (dot) Status BIT 7.
4. Press the "Set/Alarm Silence" and "Function/Test" buttons at same time again
and hold for one second. The alarm buzzer will sound one short beep to acknowledge the
UPS has stored the settings.
C. Setting load segments for continuous mode operation
1. Press the "Function/Test" and "Set/Alarm Silence" buttons at same time and hold
them for one second. The unit will emit one alarm beep and then enter the
Configuration Mode.
2. Press the "Function/Test" button repeatedly and move the dot to function BIT 3 (for
load segment 1), or BIT 5 (for load segment 2).
3. Press the "Set/Alarm Silence" button once to turn off (no dot) Status BIT 7.
4. Press the "Function/Test" button repeatedly and move the dot to function BIT 4 (for
load segment 1), or BIT 6 (for load segment 2).
5. Press the "Set/Alarm Silence" button once to turn off (no dot) Status BIT 7.
6. Press the "Set/Alarm Silence" and "Function/Test" buttons at same time again
and hold for one second. The alarm buzzer will sound one short beep to acknowledge the
UPS has stored the settings.
23