Effects Section - E-Mu MORPHEUS Operation Manual

TO PROGRAM AN EFFECT:
1) Press the MIDIMAP button lighting the LED.
2) Slowly turn the data entry knob clockwise until you find the screen
shown below. Select one of the effect processors in the Mix Selec-
tion. This selects the input to the effect processors.
3) Set the FX Amount for the A or B effect. This adjusts the ratio of
effected to un-effected signal. B->A allows you to route the output
of effect B through effect A (set the MIX to effect B).
4) Select the desired Effect and program the appropriate parameters.
VOL PAN MIX C01
127 =P FXA
FX AMOUNT A:50%
B->A:0% B:50%
FXA:Echo
L Delay Time 255
Chapter 5: Effects Section

EFFECTS SECTION

••• The diagram on the
previous page illustrates the
function of Mix Select.
••• Setting the B->A percent
age to maximum selects
"Only" which disconnects
effect B from the main
outputs and routes all of the
signal through effect A.
If the B->A amount is set
to "Only", no sound will
result if "No Effect" is
selected for effect A
41