Changing The Computer Network Settings; Connected Directly; Connected Via Crossover Cable; Connected Via Hub - Polycom RAS 200I Getting Started Manual

RAS 200I Getting Started Guide
6

Changing the Computer Network Settings

Connected Directly

If you are connected to the Polycom RAS 200I server directly with a
keyboard, monitor,and mouse, skip this section and go to
"Completing the First Time Setup."

Connected Via Crossover Cable

If you are using a PC connected to the Polycom RAS 200I server via a
crossover cable, you must change the TCP/IP settings on the PC to:
•
•
To do this, see
on page 7.

Connected Via Hub

If you are using a PC connected to the RAS 200I server via a hub, you must:
1
2
3
6
Turn the Polycom RAS 200I server off, connect it to the target
network and power it back up.
IP Address: 192.168.1.37
Subnet Mask: 255.255.255.0
"Configuring the PC Network to Connect to the RAS 200I"
Change your computer's network's settings. To do this, see
"Configuring the PC Network to Connect to the RAS 200I"
Configure the Polycom RAS 200I server. See
the First Time Setup."
Restore your computer's orginal network settings.
Chapter 2,
on page 7.
Chapter 2, "Completing
Polycom, Inc.