Modifying The Main Parameters (Without Specific Button); Exiting The Programming Phase; Table Of Remote Control Technical Specifications - Carel heaterSteam User Manual

Modifying the main parameters
The parameters without a specific button can also be modified, proceeding as follows:
perform the operations for the enabling of the remote control;
press the or button until the code of the required parameter is displayed;
press the SEL button to display its value; then press
temporarily confirm the new value;
to modify other parameters, repeat the same operations.

Exiting the programming phase

To exit the programming phase and save the modifications made to the parameters, press the PRG button.
To exit without saving the modifications, press the CANCEL button.
To exit the programming phase without confirming the modifications made:
do not press any button for 60 seconds, if the parameter code is displayed;
do not press any button for 120 seconds, if the value of the parameter is displayed.

Table of remote control technical specifications

type
power supply
case
dimensions (mm)
storage temperature (°C)
operating temperature (°C)
type of transmission
weight (g)
Carel code +030221761
(without specific button)
or again to increase or decrease the value; finally, press SEL to
description
2 (two) 1.5V mini alkaline batteries (type UM-4 AAA, IEC R03)
plastic
60 x 160 x 18
-25 70
0 40
infra-red
80 (without batteries)
40
Tab. 12.4.1
preliminary version - rel. 2.0 - 03/09/99
heaterSteam