Positioning The Unit; Fastening - Carel heaterSteam User Manual

5. POSITIONING THE UNIT

The humidifier must be positioned and fastened by qualified technical personnel, following the instructions
listed herein.
Choose the best location for the installation of the steam distributor, that is the
position which minimises the length of the steam tubing or, in the case of direct
ambient humidification using a ventilated distributor, the central point of the
space being humidified (see STEAM DISTRIBUTION). The unit is designed to
be mounted to a wall which must be able to support its weight in operating
conditions (see Dimensions and weights).
The metal casing of the humidifier heats up during operation, and the rear part
resting against the wall may reach temperatures above 60°C; thus ensure that this
does not cause any problems. Make sure the machine is level, respecting the
minimum distances indicated in the drawing, to allow the necessary maintenance
operations.
WARNING: ensure that the cooling fan outlet grid is not blocked or covered.

5.1 Fastening

The appliance must be fastened to the wall using three screws: two upper screws,
to fasten the support bracket, and a lower, central screw, for anchoring. Use the following distances for the drilling template.
X
= =
Y
Fig. 5.1.1
Fig. 5.1.2
Hang the appliance on the bracket using the contour on the upper edge of the rear of the unit.
Finally, fasten the appliance to the wall using the hole in the centre rear of the base. This can be easily reached from the
bottom.
Carel code +030221761
Fasten the bracket supplied with the humidifier to the wall, checking that it is horizontal
using a spirit level; if it is mounted to a brick wall, the plastic wall plugs (Ø 8mm) and screws
(Ø 5mm x L = 50mm) supplied can be used.
UR002
UR004
X (mm) 220
Y (mm) 520
Z (mm) 280
Z
30
10
preliminary version - rel. 2.0 - 03/09/99
heaterSteam
300
200
< 0,5°
700
Fig. 5.1
models
UR006 UR020
UR010 UR030
220
654
280
Tab. 5.1.1
30
griglia
200
400