Mounting The Unit; Receipt And Storage; Dimensions And Weights; Removing And Replacing The Front Casing - Carel heaterSteam User Manual

4. MOUNTING THE UNIT

4.1 Receipt and storage

Check the integrity of the machine upon delivery and immediately notify the shipping agent, in writing, of all and any damage
which may be the result of careless or incorrect transport. Move the machine to the place of installation before removing it
from its packaging, holding the neck only from below the base. Open the cardboard box, remove the padding material and then
the machine, keeping it vertical at all times; remove the protective bag only just prior to installation.

4.2 Dimensions and weights

reference
A
dimensions (mm) B
C
packaged
weight (kg) empty
installed *
*: in operating conditions, filled with water

4.3 Removing and replacing the front casing

To remove the front casing of the humidifier, proceed as follows:
1. turn the oval badge with the Carel logo 90°, until the ground screw below
can be seen;
2. remove the screw, using a screwdriver;
3. grip the casing by the sides and lift it around 2 centimetres, releasing the
contours from the raised edges on the cover and the base of the structure;
4. remove the casing by pulling it forward.
To close the appliance, proceed as follows:
1. turn the red oval plate with the Carel logo so that the fastening hole below is
visible;
2. slide the casing onto the structure, keeping it in a slightly raised position,
until it rests on the edges of the rear piece; then move it downwards slotting
the upper and lower contours into the edges of the cover and the base of the
structure respectively; check that the fastening hole below the logo is in line
with the threaded bush attached to the structure;
3. fasten the ground screw using a screwdriver;
4. place (rotate) the oval plate with the Carel logo in the closed position.
Carel code +030221761
models
UR002 UR004 UR006 UR010 UR020 UR030
370 370 370 370
280 280 280 280
575 575 710 710
26 26 31 31
21 21 26 26
27 27 35 35
9
C
Tab. 4.2.1
Fig. 4.3.1
preliminary version - rel. 2.0 - 03/09/99
heaterSteam
B
A
Fig. 4.2.1