Table of Contents
Advertisement
Installation Instructions
Preparing for Installation
WARNING
• If the gas or electric service provided does not meet the product specifications, do not proceed
with the installation. Call the dealer, the gas supplier or a licensed electrician.
• Before installing the range, you must locate and secure the anti-tip bracket to the floor.
Unpacking the Range
Unpack the parts box and verify that all required components have been provided. If any item is
missing or damaged, please contact your dealer immediately. Do not install a damaged or
incomplete appliance.
Installing the Anti-tip Bracket and Foot
There are two ways to mount the anti-tip bracket: Floor mounting (preferred), and wall mounting
(Pg. 22). Use this method if floor mounting is unsuitable; however, if the range's front panel is over
26 1/2" (67.3 cm) from the back wall or if the floor is too thick, floor mounting must be used.
Floor-Mounting the Anti-Tip Bracket
WARNING
To perform as designed, the anti-tip bracket must attach to the concrete slab or wood sub-floor
below any upper flooring (including cement board). Do not attach the anti-tip bracket directly to
floor coverings such as ceramic/asphalt tile or linoleum.
Floor covering
Sub-floor
Screws attached
through flooring
into sub-floor
20 English
Anchors shown
(concrete
sub-floor only)
• Four plastic anchors are provided with
three sizes (4 each) of #8 or #12 Phillips
head screws for attaching the anti-tip
bracket to the floor. Use both anchors
and four of the screws to attach the
bracket to a concrete sub-floor. Do not
use anchors on a wood sub-floor.
• Determine the location of the range
center line and front panel for the
range's final position based on the
Product Dimensions (Pg. 14) and the
actual cabinet/cutout dimensions used
for the installation.
Advertisement
Table of Contents
