Insert Placement Requirements; Hearth Requirements; Insert Size Requirements - Travis Industries Freedom Bay Owner's Manual

I P
NSERT LACEMENT
¥ The insert must be placed so that no combustibles are within, or can swing within (e.g. drapes,
doors), 36" of the front of the insert
¥ Insert and hearth must be installed on a level, secure floor
¥ Sidewalls must maintain a minimum 15" to the insert
¥ Non-combustible side facing must extend 13 1/2" from the insert
¥ Non-combustible top facing must extend 30" above the insert (17" with mantle shield)
¥ Mantle must be a minimum 32" above the insert (19" with mantle shield)
¥ Hearth must extend 16" in front of the faceplate
¥ Hearth must extend 8" from the sides of the insert
Measure side
clearances
from here.
Sidewall
H R
EARTH EQUIREMENTS (See the illustration above)
¥ Must extend 16" in front of the insert and 8" on both sides (total of 20 3/4" deep by 45 1/4" wide)
¥ Must be non-combustible and at least .018" thick (26 gage)
I S R
NSERT IZE EQUIREMENTS
R
EQUIREMENTS (See the illustration below)
D
Surround
Panels
A
B
E
F
B
A
E
C
F
I I
NSERT NSTALLATION
Combustible Mantle
Non-Combustible
Facing
C
D
(C .)
ONT
Minimum Masonry
Clearances Fireplace
A Sidewall to Insert
B Side Facing
C Top Facing
With mantle shield
D Mantle to Insert
With mantle shield
E Hearth (Front)*
F Hearth (Side)**
* Measure from faceplate, does
not include the distance the insert
sticks out on the hearth (4 3/4").
**Total hearth width must be at
least 45 1/4"
Minimum
Masonry
Fireplace Size
Fireplace
A Height* (front) 21 3/4"
B Height* (rear) 21 3/4"
C Width (front) 29 1/4"
D Width (rear) 291/4"
E Depth 15 3/4"
F Hearth** 4 3/4"
* Older model panels may use the
heightened yoke, adding 7/8" to
the height. Furthermore,
additional room is needed to align
the pipe on positive and direct
connect installations.
** Does not include the required
16" of floor protection in front.
P 7
AGE
15"
13 1/2"
30"
17"
32"
19"
16"
8"