Insert With Face Seal Connection - Travis Industries Freedom Bay Owner's Manual

I
NSERT WITH
F S
ACE EAL
C
ONNECTION
NOTE:
Face seal
connections
require
installation of
the surround
panels and
insulation (see
the section
"Surround
Panels
Installation"
on page 29).
NOTE: This installation may be
used with a masonry fireplace
only. The requirements in the
section "Masonry Fireplace
Requirements" must be fulfilled
prior to installation.
Flue Liner
Combustible Mantle
Surround Panels with
insulation (see "Surround
Panels" installation
instructions in the back of
the manual)
See the section "Insert
Placement Requirements"
for minimum clearances
and hearth required.
I I
NSERT NSTALLATION
(C .)
ONT
P
AGE
NOTE: It is
recommended your
chimney have a
minimum 28 and a
maximum of 144
square inch
cross-sectional area
to use a face seal
connection, otherwise
your chimney maynot
have sufficient draw
for the fireplace insert
to operate correctly.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
11