Advertisement
Quick Links
(Birch - sku# 94500982) (Oak - sku# 94500983).
Compatibility
4327 EG Fireplaces
Packing List
9 Piece Log Set
Installation Warnings
NOTE: Consult the installation manual for order of installation. If using propane (LP), convert the appliance
before installing the log set. If using firebacks, install them prior to installing the log set.
The logs are fragile, especially after being exposed to heat.
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.
The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated and
the pilot is properly aligned. See owner's manual for details on burner removal.
Installation – Oak vs. Birch
Both log sets are nearly identical in shape. The only difference is the paint scheme and some textural details.
Below you will find pictures of both the birch and the oak log sets. The installation pictures show the oak log
set.
Log Set Overview - Oak (sku# 94500983)
When installed, the nine (9) logs should appear as shown below.
Log #2
250-05841
Log #6
250-05845
Log #5
250-05844
Page 1 of 10
4237 EG - Oak & Birch Log Set
WARNING
Log #8
250-05847
17602208 —9/15/2021
Log #1
250-05840
Log #9
250-05848
Log #7
250-05846
Log #3
250-05842
Log #4
250-05843
© Travis Industries, Inc.
Advertisement
Related Manuals for Travis Industries House of Fire 4237 EG
Summary of Contents for Travis Industries House of Fire 4237 EG
- Page 1 When installed, the nine (9) logs should appear as shown below. Log #1 Log #7 250-05840 250-05846 Log #2 250-05841 Log #3 250-05842 Log #6 250-05845 Log #9 Log #4 250-05848 Log #5 Log #8 250-05843 250-05844 250-05847 Page 1 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 2 When installed, the nine (9) logs should appear as shown below. Log #1 Log #7 250-05824 250-05830 Log #2 250-05825 Log #3 250-05826 Log #6 250-05829 Log #9 Log #4 Log #8 250-05832 Log #5 250-05831 250-05827 250-05828 Page 2 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
-
Page 3: Log Set Installation
NOTE: If power is supplied, turn the rheostat up until the embers have a realistic and aesthetically pleasing appearance. Use the remote to turn the Ember-Glo™ lights on and off. Page 3 of 10 17602208 —9/15/2021 © Travis Industries, Inc. - Page 4 LP gas or pull it forward if using NG gas. Bottom View of Log Push back for LP gas Pull forward for NG gas Page 4 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 5 Push the log backward until it is in contact with the sloped portion of the rear burner. Make sure burner holes are not obstructed. Page 5 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 6 8. Place log #5 as shown below. There is a notch on the lower right of the log that rests against the leftmost fireplace grate finger. The upper portion of the log rests on a flat spot on the top of log #2. Page 6 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 7 #6 onto the left locating pin on the top of log #2 10. Place ember chunks (included with the fireplace) along the front of the front burner. Do not obstruct any burner holes. Page 7 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 8 #1(see below). The other end of log #7 rests on the right end of log# 3. Rotate the lower portion of the log until it is in contact with the fireback. Page 8 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 9 Ember-Glo™ glass. Push the log down until it is resting on the front edge of the log grate rather than being held up by the ember glass. Place the hole on the right locating pin on log #2 Page 9 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
- Page 10 (see below). Work the end of the log into the glass until it is stable. Log #1 14. Finish dressing the firebox with ember chunks over the top of the ember glass in front of the log set. Page 10 of 10 17602208 —9/15/2021 © Travis Industries, Inc.
Need help?
Do you have a question about the House of Fire 4237 EG and is the answer not in the manual?
Questions and answers
Remote won’t turn off—- what do I do?
If the remote for the Travis Industries House of Fire 4237 EG won't turn off, ensure that power is supplied to the fireplace and check the rheostat setting. If the power and rheostat are functioning properly, try manually turning off the Ember-Glo™ lights using the remote again. If the issue persists, further troubleshooting may be necessary.
This answer is automatically generated