Table of Contents
Advertisement
Firebrick Removal and Replacement Instructions
With the appliance cool, remove all ash from the firebox. Only the firebrick that is damaged must be
replaced. If the damaged firebrick is on the floor, it can be replaced by simply removing the firebrick in
front of it. NOTE: Do not pry firebrick to remove, this will chip or crack the firebrick. If a
firebrick on the wall of the firebox needs replacement, the floor firebrick near it will need to be removed
first. The wall firebrick is held upright by a clip on the walls of the firebox. To remove, pivot it out
from the bottom. See the illustration below.
WALL FIREBRICKS
First remove the firebricks
on the floor in front of the
firebrick needing
replacement. Then pivot it
out from the bottom to clear
the clip that holds it in place.
FLOOR FIREBRICKS
Remove the firebricks in
front of the firebrick
needing replacement.
FIREBRICK SIZES -
All firebrick is 1 1/4" x 4 1/2"
x 9" except those labeled.
Firebrick labeled
1 1/4" x 4 1/2" x 6 3/8".
Firebrick labeled
1 1/4" x 4 1/2" x 8 1/4".
Baffle Removal and Replacement Instructions
The view below details the baffle components. Instructions for removal are on the following page.
Bypass Rod - threaded in two locations for easy removal
Bypass
Damper
Bypass Support - note
its orientation and how
it rests on the rear
baffle firebrick
M
AINTAINING
A
are
B
are
Bypass Handle
Y
A
OUR
PPLIANCE
CLIPS -
Hold the wall firebrick in place.
A
Baffle supports rest on these tabs
(C
ONTINUED
B
A
Baffle
Firebrick
)
P
23
AGE
Center
Baffle
Support
Forward
Baffle
Support
Advertisement
Table of Contents
