User Controls - Hatteland HD 08T21 STD-xxx-Fxxx User Manual

User Controls

USER CONTROLS OVERVIEW
The units are designed by using HATTELAND® Glass Display Control™ (GDC) touch technology to allow
interactivity adjusting brilliance (brightness) and control power on / off with the use of illuminated symbols. Note that
these symbols are only visible (backlight illuminated) when suitable power is connected. There is no physical moving
knobs, potmeters, wheels or push buttons available as everything is touch surface controlled by Projected Capacitive
technology, that allows a human finger (including several types of gloves) to control the unit.
Light Sensor:
Used to sense level of ambient light in the surrounding environment. The sensor data can be read by suitable software
through the Hatteland Display SCOM functionality of the unit and thus can be used to control brightness remotely.
Note: This sensor is not visible for the eye or has any illumination behind to indicate it's position. Further, by touching
or covering this area will naturally make the sensor data inaccurate.
Programmable Alarm LED:
Used to indicate an Alarm or similar functionality. The logic to this LED can be programmed through customized API
which gives access to controlling its function and for instance setup blinking patterns. Note: This LED (when not
activated) is not visible for the eye or has any illumination behind to indicate it's position. Further, by touching this area
no action will be performed or has been assigned.
Brightness Adjust:
Brilliance / Brightness adjustment of the displayed image is adjusted by touching the (-) or (+) illuminated symbols.
Both symbols are visible as long as the unit is powered.
Power ON/OFF:
Touching this symbol will either turn on or off the unit.
Operation
IND100064-36
Programmable Alarm LED
Light Sensor Brightness Adjust -
20
Power On/Off
Brightness Adjust +
INB100535-2 (Rev 1)