Power Inputs - Hatteland HD 08T21 STD-xxx-Fxxx User Manual

Physical Connections
Note: For details about the connectors below,
please review the "Pinout Assignments" section in this manual.
Connect a TYPE B USB Cable between this connector and your PC. Suitable drivers to install and calibrate the
touchscreen are available on the separate installation media delivered with the unit. USB1.1 is suitable for cable
distances above 10meter/32.8 feet, whereas USB2.0 is suitable from less than 10meter/32.8 feet distances.
Connect your DVI cable to the DVI-I 29P Connector (female). The DVI-I connector can function as regular RGB IN by
using a DVI-I > RGB/VGA adapter. Secure the DVI cable to the hex spacers provided on the unit and make sure you
do not bend any of the pins inside the connector. Connect the other end of the cable to the DVI connector on your
equipment and secure it.
Important note for DVI signal detection:
Please note that for the operating system to detect DVI signals correctly, the DVI cable MUST be connected physically
to the unit during boot up otherwise you may experience a black image. Furthermore certain graphics drivers may
need to refresh their device list (often done manually by user - detect devices), while in some cases the Plug-n-Play
will automatically detect the DVI signal correctly. Please consult your local technician if you have this behaviour of
detection problems when using DVI. In all cases the problem can be solved in the operating system, and this is not a
malfunction in the graphic controller for display units.
Connect your DC power cables to the SL-SMT 90F connector block. The internal DC power module supports 24VDC.
The unit offer both Primary and Secondary power inputs for secure operation of the unit as well as; galvanic isolated
and automatic switch between power source.
Note: DC models are required / recommended to be properly grounded via the
review "General Installation Chapter", pt. 6 for more information.
IND100133-50
USB TOUCH:
DVI-I IN:

POWER INPUTS:

GROUNDING SCREW:
18
INB100535-2 (Rev 1)
screw located on the unit. Please