Care And Cleaning - Gree E-TAC Installation And Operation Instructions Manual

CARE AND CLEANING
FRONT PANEL AND CASE
Turn unit off and disconnect power supply.
To clean, use water and a mild detergent. DO NOT
use bleach or abrasives. Some commercial cleaners
may damage the plastic parts.
OUTDOOR COIL
Coil on outdoor side of unit should be checked
regularly. Unit will need to be removed to inspect
dirt build-up that will occur on the inside of the coil.
If clogged with dirt or soot, coil should be
professionally cleaned.
NOTE: Never use a high=pressure spray on coil.
Coils
Grille
Clean inside and outside of outdoor coils regularly
Fig. 27 = Outdoor Coil
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Airflow restriction may cause damage to the unit.
BASE PAN
In some installations, dirt or other debris may be
blown into unit from outside and settle in base pan
(bottom of unit).
In some areas of the United States, a "jell=like"
substance may be seen in the base pan. Check base
pan periodically and clean, if necessary.
AIR FILTERS
IMPORTANT: TURN UNIT OFF BEFORE
CLEANING
UNIT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
Do not operate unit without filters in ptace. If a filter
becomes torn or damaged, it should be replaced
immediately.
Operating without filters in place or with damaged filters
will allow dirt and dust to reach indoor coil and reduce
cooling, heating, airflow and efficiency of unit. Airflow
restriction may cause damage to unit.
F
ili ii iiii ili
ii/i iiiii/i ii I
Dirty filter- Clogged filter -
Needs cleaning Greatly reduces cooling,
heating and airflow.
Fig. 28 - Identifying Clogged Filter
The most important thing you can do to maintain unit
efficiency is to clean the filters at least every 30 days
(or sooner depending on application). Clogged filters
reduce cooling, heating and airflow.
Keeping filters clean wilh
. Decrease cost of operation.
* Save energy.
* Prevent clogged indoor coil.
* Reduce risk of premature component failure.
To Clean Air Filters:
" Vacuum off heavy soil.
* Run water through filters.
* Dry thoroughly before replacing.
Pull u 2 Air filters
Push down
.... Fig. 29 - Removing and Replacing Air Filter
Removing Air Filter Replacin Air Filter
16