Gree ETAC Installation Manual
Ir remote control system
Hide thumbs
Also See for ETAC:
- Installation and operation instructions manual (24 pages) ,
- Specifications (47 pages)
Advertisement
Introduction: These instructions cover the installation and operation of the ETAC IR Remote
Control System.
Contents:
DISCONNECT ALL ELECTRICAL POWER TO UNIT BEFORE INSTALLING
ETAC IR REMOTE CONTROL SYSTEM. FAILURE TO DO SO MAY CAUSE
PROPERTY DAMAGE, PERSONAL INJURY OR DEATH.
Installation Procedure:
Step 1: Remove front panel from ETAC unit by pulling front panel
out at the bottom (1) and then lift up (2).
Step 2: Locate IR Receiver module mounting holes and electrical
connector on the front face of the electrical control box.
GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI
Remote Control
WARNING
ETAC IR REMOTE CONTROL SYSTEM
IR Receiver
INSTALLATION GUIDE
Page 1
Advertisement
Table of Contents
Related Manuals for Gree ETAC
Summary of Contents for Gree ETAC
-
Page 1: Installation Guide
INSTALLATION GUIDE ETAC IR REMOTE CONTROL SYSTEM Introduction: These instructions cover the installation and operation of the ETAC IR Remote Control System. Contents: Remote Control IR Receiver WARNING DISCONNECT ALL ELECTRICAL POWER TO UNIT BEFORE INSTALLING ETAC IR REMOTE CONTROL SYSTEM. FAILURE TO DO SO MAY CAUSE PROPERTY DAMAGE, PERSONAL INJURY OR DEATH. - Page 2 (1). Then swing the front panel down and inward until it snaps into place (2). Step 7: Installation is complete. Plug in unit and apply electrical power to ETAC. IR Remote Control System is ready for use. (No additional configuration or setup is required) GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI...
-
Page 3: Remote Control Operation
Under Auto mode, the temperature will not be displayed; Under Heat mode, the initial value is 82°F; Under other modes, the initial value is 77°F. AUTO COOL HEAT AUTO COOL HEAT GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 3... -
Page 4: Timer Button
2 seconds, the set temperature values will change rapidly, until the button is released. The set temperature will be displayed in °F or °C. Note, in Auto mode, the room temperature cannot be set. GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 4... -
Page 5: Start-Up Guide
Display Light The remote control display backlighting can be turned On aor Off by pressing the "+" and "FAN" buttons simultaneously for 3 seconds. On initial power up, the backlighting defaults to On. GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 5... - Page 6 To reset the remote control, remove batteries for 30 seconds. Then reinsert batteries and remote control will default to factory settings. Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations. 66161332 GREE ELECTRIC APPLIANCES, INC.OF ZHUHAI Page 6...
Need help?
Do you have a question about the ETAC and is the answer not in the manual?
Questions and answers