Troubleshooting - Strong PRIMA V User Manual

PART 1 • English
7.6.4 HDD format
The HDD format menu allows you to format the connected USB device.
WARnInG!
Select HDD Format from the Media+ menu and press ok to enter. Use tu to select the partition you
wish to format (Partition 1 is set per default) and press q to highlight Format. Press ok to proceed,
select FAT or Cancel, or press EXIT to leave without formatting.
noTE It is possible to use already NTFS formatted USB disks.
7.6.5 DVR Configuration
This menu allows you to make settings for Time Shift, recording and playback.
Select DVR Configuration from the Media+ menu and press ok to enter.
Use pq to move the highlight and tu to change settings.
Press EXIT to quit.
Time Shift:
Time Shift to Record:
Record Type:
Record Selection
Standby after record:
Step to:

8.0 TRoUblEsHooTInG

There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
Problem
LED indicator not lit
No signal found
Formatting will permanently delete ALL data stored on the connected device.
Please make a backup copy of all data you wish to keep before entering the
HDD Format menu. STRONG cannot be held responsible for loss of data
from USB devices used with this receiver.
On or Off. When Time Shift is set to Off, Time Shift becomes inactive.
On or Off. When set to On, Time Shift is also possible during recording.
TS or PS. When TS is selected, recordings will also include subtitles and
teletext (when available). PS makes recordings without these extras.
Select the partition whereto the receiver should record.
On or Off. Select if receiver must go to standby mode after Timer record.
30 sec to 10 min. Set the time step you like to jump forward with the numeric
button 3 during playback of recorded files.
Possible cause
Mains lead unplugged
Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to
switch ON antenna power/
external power
What to do
Check mains plug
Check aerial lead
Check aerial
Check with dealer
Switch receiver's Antenna
Power ON/connect
external power
17