Technical Specifications - Strong PRIMA V User Manual

Problem
No picture or sound on TV
Scrambled channel
Message
No response to remote
control
Forgotten PIN code
After moving the receiver
to another room/area you
are no longer able to receive
digital reception
The receiver switches
off automatically.

9.0 TECHnICAl sPECIfICATIons

Demodulator:
Demodulator:
Transmission mode:
Video Decoder:
Profile level:
Video resolution:
Decoding & Video Out:
Aspect ratio:
Audio Decoder:
Audio support:
MPEG MusiCam Layer 2
Sampling rate:
Audio mode:
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.
18
Possible cause
HDMI is not selected on
your TV or Amplifier or is
set to higher resolution as
TV supports
TV is not switched on
Channel is scrambled
Receiver off
Remote not aimed correctly
Front panel obstructed
Remote batteries exhausted
Antenna signals are too weak
Auto Standby function enabled. Disable auto standby. See
COFDM; 16 QAM/64 QAM
2 K - 8 K
MPEG-2 MP@ML, AVC/H.264HP@L4.1,
MPEG-4 ASP supported
576i, 576p, 720p, 1080i, 1080p
PAL
4:3 Letterbox, 4:3 Pan & Scan, 16:9, Auto
AAC/DD+*/AC3/PCM
32, 44.1, 48 KHz
Stereo, Dual Mono, Mono
PART 1 • English
What to do
Switch to correct TV input
Select lower resolution
on receiver
Switch TV on
Select alternative channel
Plug in and turn on plug
Aim remote at front panel
Check for obstructions
Replace remote batteries
Default PIN is 0000
Contact local Service Hotline
or send email to our Support
via www.strong.tv
Press the Info button on
remote 3x to call up signal
bars and adjust antenna for
(maximum) reception
or rescan channels
section 7.3.8 for details.