Starting Up For The First Time - Strong PRIMA V User Manual

indications for a low device speed. STRONG cannot guarantee proper functioning of recoding and or
Time Shift functions with all USB devices.

4.0 sTARTInG UP foR THE fIRsT TIME

If you use your receiver for the first time, the Welcome "Easy install" menu appears. Use pq to move
the highlight to the setting you wish to alter and use tu to change values. Start by selecting your
language using tu. Once you have selected your language, press q to move the highlight to the
next item and use tu to change.
Language
Region:
Subtitle:
Aspect Mode:
Scan mode:
Connection:
When all settings have been made, move the highlight to OK and press ok to continue.
note:
The receiver will now advance to the Aerial Adjustment screen.
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to alter and use tu to change values. The
following settings are available:
Antenna Power:
Beeper:
Channel No.:
Once all settings are made, press ok to start scanning.
The receiver will now search for all available channels. Once scanning is finished, the receiver
switches to viewing mode.
TIP:
6
Select your language.
Select your region where this receiver is used.
Select Normal to display subtitles per default, Select Hard of Hearing to show
HoH subtitles per default. Select Off to hide subtitles per default.
Use this option to select the aspect ratio of your TV and the preferred
conversion method. Options are: Auto (automatic detection of aspect ratio),
4:3 Panscan (Displays 16:9 widescreen broadcasts full screen on your 4:3 TV),
4:3 letterbox (black bars on top and under the picture on a 4:3 TV) and 16:9
(use this setting for 16:9 TV sets).
Select All to store scrambled and free to air channels or select Free to store
only free to air channels. Note: Scrambled channels you cannot watch with
this receiver.
Use this option to select the connection to your TV set. Select HDMI or
SCART.
Wrong region selection can lead to missing channels or channels being
stored on wrong positions in the channel list.
Set to On if you use an active antenna. When set to On, 5 V will be present on
the ANT IN connector of the receiver. Select Off for passive antennas.
Select On for an audible indication of signal reception. Off turns the
beeper off.
Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
If the Welcome "Easy install" menu does not appear after switching on the
receiver the first time, reset the receiver to factory settings by pressing the
MEnU button and selecting Load Factory Setting in the submenu Tools.
(Default PIN 0000)
PART 1 • English