Headset Mode [Feature]O - Comdial DX-80 User Manual

4.2. To program a feature code, press [ftr].
4.2.1. Press the [FEATURE] button.
4.2.2. Input the feature code y# (for CID Table review) and
5. Continue programming other Flexible Feature Buttons or lift/replace
the handset to exit this programming.
Headset Mode
All Digital Speakerphones have a standard 2.5 millimeter headset jack.
When Headset Mode is selected (either by pressing a preprogrammed
headset feature key or dialing the Headset Mode code), the ON/OFF button
is used to activate/deactivate the headset.
When you press the ON/OFF button, Headset Mode active and the
extension status changes to an off-hook condition. When you press the
ON/OFF button again, the extension status returns to idle, disconnecting
any call in progress.
Operation – Activate Headset Mode
1. While the telephone is idle, press [FEATURE]o# or press the
Flexible Feature button designated as HEADSET MODE (if available).
The display indicates the new status:
Operation – Deactivate Headset Mode
1. While the telephone is idle, press [FEATURE]o# or press the
Flexible Feature button programmed with the Headset Mode code.
The display indicates the new status:
Operation – Use the Headset to Place a Call
1. While the telephone is idle, press the ON/OFF button, a DSS button,
or outside line button. The ON/OFF button LED flashes to indicate that
the headset is active. You hear Intercom dial tone, outside line dial
tone, or Intercom ring-back tone, depending on the function invoked.
2. Press ON/OFF again to disconnect the current call.
Page 42
FTR CODE:_
bksp save chg
then press [save].
HEADSET ENABLED
HEADSET DISABLED
[FEATURE]o#
P7292 DETUG 03/01-1