Messaging - Status Text [Feature]Op - Comdial DX-80 User Manual

Operation – Receiving a Call in VA-HF Mode
When your extension is idle, you will be alerted of intercom calls by
one tone burst. The voice connection is then established immediately
and you may respond to the calling extension without lifting the
handset.
Operation – Receiving a Call in VA-Privacy Mode
1. When your extension is idle, you will be alerted of an intercom call by
one tone burst. The voice connection is then established immediately
with the Mute function activated at your extension. You hear the calling
extension voice announcement over the speaker, but the microphone
in your telephone is disabled.
2. You can:
2.1. Lift the handset to speak confidentially with the caller.
2.2. Press the MUTE button to deactivate the Mute feature and speak
with the caller hands-free (using speakerphone mode).
Operation – Receiving a Call in Tone Mode
1. When your extension is idle, you will be alerted of an intercom call by
a double-burst tone which is repeated until you respond or until the call
follows a Call Forward route.
2. You can:
2.1. Lift the handset to speak confidentially with the caller.
2.2. Press the ON/OFF button to activate the speakerphone and
speak with the caller using the speakerphone.
Messaging – Status Text
You can invoke a display message to inform other users of the current
status of your extension. There are six programmed messages and one
custom message that you can use. Whenever another digital speakerphone
user calls an extension with an active Status message, the message is
displayed at the calling extension.
Operation – Setup
1. The extension must be idle.
2. Press [FEATURE]op. The display shows the first message choice
(custom):
2.1. To input a custom message, press [chg] and then use the
Page 46
EMPTY
store next chg
alpha-numeric chart and dial-pad to write the message:
[FEATURE]op
P7292 DETUG 03/01-1