Dust Removal System Adjustment - Norton GC55 Owner's Manual

The collar used to support the turn handle's screw should be checked after
each use to make sure it is lubricated and turning freely. If more lubricant
must be added, NLGI #2, aluminum complex type grease is recommended.
E. Dust Removal System Adjustment
The GC55 and GC2E are equipped with a fully adjustable non-scratching
Dust removal system which helps stabilize the machine by pushing debris
way from wheels and undercarriage of the machine. Depending on the
surface and wear the Dust Removal System may need adjustments from time
to time. The Dust removal system consist of two Brushes located in front of
the Front Wheels and a large Squeegee Assembly located under the machine
and in front of the rear wheels. When this system is properly adjusted the
front wheel Brushes, and the Rear Wheel Squeegee System will barely touch
the work surface.
Before making any adjustments turn off the machine
and disconnect the spark plug.
To adjust the Rear Wheel Squeegee Assembly:
1. Loose the Squeegee Assembly mounting
hardware items 1 & 3
2. Position the Squeegee Assembly to the
required position
3. Tighten the Squeegee Assembly mounting
hardware items 1 & 3
To adjust the Front Wheel Brush:
1. Loose the Front Wheel Brush mounting
hardware
2. Position the Front Wheel Brush to the
required position
3. Tighten the Front Wheel Brush mounting
hardware
NOTE: The Left and Right Side Front Wheel
Brushes Are Different Parts
22