Preface - O.Y.L. Technology AX1 LED User Manual

AX1 LED User Manual Rev 1.0

PREFACE

Thank you for selecting the new AX1 system. This manual will explain to you on how to
operate your AX1 alarm and home automation system. This system is made up of a control
panel, keypads, integrated switch module and telephone voice module. Specific areas of
detections are called zones. Zones can be programmed to have different characteristics. Some
zones may be 24-hour zones; they remain armed even when the alarm system is in disarm
mode. (This setting is done during the installer programming as per user‟s request). In
addition, some zones can be programmed by the users to allow zone bypassing. When you
bypass a zone, the zone is temporarily removed from the alarm system. But always remember
that bypassed zones are not protected.
How your AX1 alarm and home automation system works?
When a detection device is triggered, the zone indicator will light up. If the alarm system is
armed, the control panel responds by reporting an alarm condition. The control of the system
can be done either through keypad or telephone. If the alarm system is triggered, the signal
can be transmitted to a central monitoring station (CMS). (Provided the AX1 system is
connected to CMS)
For safety purposes, the operation of the AX1 system requires the users to enter the personal
identification number (PIN). User is advised to disable the installer access whenever
necessary. (i.e. after the commissioning and servicing of alarm system.)
1