AX1 LED User Manual
4.0
PIN CODE EDIT
4.0.1 MASTER USER
Command
Step 1: Press [1] [#]
Step 2: Enter the user number : [1] [#]
Step 3: Press the new PIN : [4 - 6 digits PIN] [#] Zone light will be ON one by one to
Step 4: Repeat the new PIN: [4 - 6 digits PIN] [#]
Note:
PIN "000000" is not allowed to be used as password.
Master PIN default value: "111111"
4.0.2 USER
Command
Step 1: Press [1] [#]
Step 2: Enter the user number : [2 - 7] [#]
Step 3: Press the new PIN : [4 - 6 digits PIN] [#] Zone light will be ON one by one to
Step 4: Repeat the new PIN: [4 - 6 digits PIN] [#]
Step 5: Enter access level : [ Toggle key 1-4] [#]
Note:
PIN "000000" is not allowed to be used as password.
After enter the user number, press [#]. Press [0] [#] to delete PIN.
The Master user should change the PIN for user 1 to 8 after the installation. Even though the user
PIN is not used, the user should clear the PIN for those users by key with new PIN as "0".
Information
Zone 1 light will be ON to indicate that the
command has been accepted and the users
are in "Edit User's PIN" option.
User 1 = Master user
indicate that the PIN has been entered.
Zone light will be ON one by one to
indicate that the PIN has been entered.
The keypad will beep twice for valid entry.
Information
Zone 1 light will be ON to indicate that the
command has been accepted and the users
are in "Edit User's PIN" option.
User 2 - 7 = Normal user
indicate that the PIN has been entered.
Zone light will be ON one by one to
indicate that the PIN has been entered.
The keypad will beep twice for valid entry.
Press key 1 to key 4 to set user access level.
Key [1] –Arm and Disarm On (1)/ Off (0)
Key [2] – Arm (1)/ Disarm (0)
Key [3] – Bypass Enable (1)/ Disable (0)
] – Open/ Close Report (1)/ Disable (0)
4
Key [
*By pressing Key 1- 4 will toggle its status to
ON /OFF
The keypad will beep twice for valid entry.
Rev 1.0
20