Chapter 6: When There Is An Emergency; Emergency Alarm; Duress Alarm (Calling For Help); Tamper Loss And Phone Line Loss Alarm - O.Y.L. Technology AX1 LED User Manual

AX1 LED User Manual

CHAPTER 6: WHEN THERE IS AN EMERGENCY

6.0

EMERGENCY ALARM

In order to access this function, the system must be in normal mode
Command
If there is a „FIRE‟
Press for 2 seconds
If there is a „EMERGENCY‟
Press for 2 seconds
If there is a „PANIC‟
Press for 2 seconds
To OFF the emergency alarm alert, press [USER PIN] [#]
6.1

DURESS ALARM (CALLING FOR HELP)

In the event where the user is forced by an intruder or robber to disarm the alarm system, user
can disarm the alarm system by using Duress Code. By pressing Duress Code, user can
access the menu to disarm the system. At the same time, a silent signal will be sent to any
designated telephone number or central monitoring station (CMS) to call for help.(* Provided
the system is connected to CMS). The siren and strobe will not be activated. To set the
duress code, refer to section 4.0.4
6.2 TAMPERED AND PHONE LINE LOSS ALARM
Reporting / Zone indication
Tampered Alarm
Phone Line Loss Alarm
Information
Alarm will be triggered
ARMED LED will flash indicate soft zone
alarm trigger.
A message will be sent to the Central
Monitoring Station (CMS)
An alert tone or voice reporting will be sent
through telephone
Description
ARMED and all zone LED will fast Blink to
indicate the alarm was triggered by the tamper
switch.
ARMED and SERVICE LED will fast Blink to
indicate the alarm was triggered by the phone
line loss.
Rev 1.0
27