Testing System; Local System Test (Walk Test); Bell Test; Manual Test Reporting For Cms - O.Y.L. Technology AX1 LED User Manual

AX1 LED User Manual
7.1

TESTING SYSTEM

Users are advised to test the system frequently. System must be tested at least once every
three months. If the system is not functioning accordingly, please contact the nearest dealer
for technical assistance. In order to test , system must be on normal mode. There are 4 types
of tests: walk test, bell test, CMS test and battery test.

7.1.1 LOCAL SYSTEM TEST (WALK TEST)

Command
Initiate Walk Test
Press [COM] [1] [1] [#]
To exit, press any key.

7.1.2 BELL TEST

Command
Test bell or siren
Press [COM] [1] [2] [#]

7.1.3 MANUAL TEST REPORTING FOR CMS

Command
Manual test reporting for CMS
Press [COM] [1] [3] [#]

7.1.4 BATTERY TEST

Command
Test back-up battery
Press [COM] [1] [4] [#]
Information
 Walk test allow on-site testing for each zone of the
system
 The keypad will beep twice upon confirmation
 The SERVICE and ARMED light will FLASH to
indicate that the system is currently under the Walk
Test.
 Each time zone faulted, corresponding zone light will
fast flash and keypad will chime until system exit
walk test.
 The keypad will beep twice upon confirmation. Back
to normal mode.
Information
 Once command has been acknowledged, the keypad
and bell will sound continuously for 3 seconds.
Information
 The keypad will beep twice upon confirmation. Panel
will generate message to CMS.
Information
 Battery test takes few seconds
 The keypad will beep twice or reject tone as a result.
 The indication of low battery can be seen from View
System Trouble Mode.
Rev 1.0
32