Glossary - O.Y.L. Technology AX1 LED User Manual

AX1 LED User Manual Rev 1.0

GLOSSARY

Arming/Disarm
To ARM is to ON the alarm system and to DISARM is to OFF the alarm system
Battery
A back up power source to provide protection for a limited time in the event of a power
failure
Bypass
Removal of one or more protection zones from the system
Central Monitoring Station (CMS)
Central control station to receive the alarm message from AX1 system
Chime
A beeping tune from the keypad to indicate sensor is activated
Duress Code
In the event that you are forced by an intruder to disarm your system, you disarm the system
with the Duress Code which will cause the system to disarm and simultaneously send a silent
distress signal to the central monitoring station (CMS). Default duress code is 2222.
Entry Delay
The amount of time that you are allowed to enter the premises when the system is armed.
Exit Delay
The amount of time that you are allowed to leave the premises when the system is arming.
Guest PIN
A temporary four to six digit code which is used to arm and disarm the system from the
keypad
User PIN
A four to six digit code which is used to arm and disarm the system from the keypad
Master PIN
A four to six digit code which can be used to program, reprogram and erase user codes, as
well as arming and disarm the system from the keypad. The Master PIN is also equivalent to
user 1 PIN. Default Master PIN is 111111.
Zone
An area which is protected by a security device. Your front door may be designated as Zone
1, while the living room motion detectors maybe designated as Zone 2. Refer to the Zone
Label on your keypad for the Zone Identification of your system. The designated zone
number is set during installer programming.
33