AX1 LED User Manual
4.0.3 GUEST
Command
Step 1: Press [1] [#]
Step 2: Enter the user number : [8] [#]
Step 3: Press the new PIN : [4 - 6 digits PIN] [#] Zone light will be ON one by one to
Step 4: Repeat the new PIN : [4 - 6 digits PIN] [#]
Step 5: Enter access level : [ Toggle key 1-4] [#]
Step 6: Enter Guest Time :
Note:
Pin "000000" is not allowed to be used as password.
-
-
After enter the user number, press [#]. Press [0] [#] to delete PIN.
4.0.4 DURESS
Command
Step 1: Press [2] [#]
Step 2: Enter the Duress Code :
[4 digits Code] [#]
Note:
Duress Code default value: "2222"
-
[0 - 15] [#]
Information
Zone 1 light will be ON to indicate that the
command has been accepted and the users
are in "Edit User's PIN" option.
User 8 = Guest user
indicate that the PIN has been entered.
Zone light will be ON one by one to
indicate that the PIN has been entered.
The keypad will beep twice for valid entry.
Press key 1 to key 4 to set user access level.
Key [1] –Arm and Disarm On (1)/ Off (0)
Key [2] – Arm (1)/ Disarm (0)
Key [3] – Bypass Enable (1)/ Disable (0)
Key [4] – Open/ Close Report (1)/ Disable (0)
*By pressing Key 1- 4 will toggle its status to
ON /OFF
The keypad will beep twice for valid entry.
Valid entry is 0 - 15 for number of days.
The keypad will beep twice for valid entry.
Information
Zone 1 light will be ON to indicate that the
command has been accepted and the users
are in "Edit Duress's Code" option.
Zone light will be ON one by one to
indicate that the PIN has been entered.
The keypad will beep twice for valid entry.
Rev 1.0
21