MK-370 SAW
SETUP FOR OPERATION
CAUTION
1. Before connecting the MK-370 Saw to a power supply, be sure the voltage,
cycle and phase meet the requirements of table below.
2. If using an extension cord, make sure the length and wire gauge
correspond to the requirements listed in the table on page 16. An extension
cord that is too small in wire gauge (diameter), or too long in length, will
cause the motor to overheat and could cause premature failure.
3. Before connecting the MK-370 Saw to a power supply, be sure the voltage,
cycle and phase of the job site power source meet the requirements in the
table below.
4. Plug the MK-370 Saw into a wall outlet with built-in GFCI protection.
5. Do not cover the motor vents as this could lead to motor overheating.
VOLTAGE
CYCLE
PHASE
120v
60Hz
1-phase
18
OPERATION