MK Diamond Products MK-370 Owner's Manual page 25

MK-370 SAW
NOTE:
"Rodding" cooling channels is performed by inserting a small wire rod through the cooling
inlet on top of the Blade Guard and directing the rod out through each of the cooling
flow tubes located on the underside of the Blade Guard. The cooling channels should be
"rodded" until all ports are free of foreign debris.
(D)
Remove the Blade Guard Intake
Fitting
(G)
Rod Cooling Channels and
recheck flow
MOVABLE CUTTING TABLE DOES NOT MOVE CORRECTLY
(A)
Check the Guide Bar and Roller
Wheel Guide Frame is clean -
clean if dirty
(E)
Clean the Blade Guard Intake
Fitting
(B)
Check the Movable Cutting
Table Roller Wheels for wear
replace if necessary
25
TROUBLESHOOTING
(F)
Locate the Blade Guard Cooling
Channels