Troubleshooting - MK Diamond Products MK-370 Owner's Manual
Tile saw
Hide thumbs
Also See for MK-370:
- Owner's operating manual (12 pages) ,
- Owner's manual (10 pages) ,
- Owner's manual & operating instructions (38 pages)
Table of Contents
Advertisement
MK-370 SAW
TROUBLESHOOTING
BLADE STOPS TURNING
(A)
(B)
(C)
Check the ON/OFF Switch is in
Verify all plugs are fully connected.
Verify circuit breaker not
the ON position
Check to see if the wall outlet
tripped; if it is tripped, reset it
Ground Fault Circuit Interrupter
once only
(GFCI) is tripped.
(D)
Check power source voltage
is 120v - if not 120v, move to
another circuit
26
Advertisement
Table of Contents
Troubleshooting
