MK Diamond Products MK-370 Owner's Manual page 15

MK-370 SAW
(D)
Place the Blade Wrench on
the Blade Retaining Nut and
remove the Blade Retaining
Nut and Outer Flange
(G)
Install the Outer Flange and
Retaining Nut; install the Shaft
Wrench and Blade Wrench as
shown in Steps C and D and
tighten the Retaining Nut
(E)
Install Diamond Blade onto
Blade Shaft
(H)
Close the Blade Guard and
tighten the Blade Guard
Retaining Knob
15
INSTALLATION
(F)
Verify the Directional Arrow of
the Blade faces outward and
matches the Directional Arrow
of the Blade Guard
(I)
Tighten the Blade Guard
Retaining Wingnut