Kenmore 66592172301 Installation Instructions Manual page 9

4. Insert theother 2 wires (lines 1 and 2)under theother 2 screw
clamps.
A. Insert wire under screw clamp
B. Hex washer head screw
5. Securely tighten the hex washer head screws to 35 in.-Ibs
minimum torque to make proper electrical connection.
6. Tighten the locking ring of the conduit connector.
7. Replace the terminal block cover.
3-wire connection: Direct wire
Use this method only if local codes permit connecting ground
conductor to neutral supply wire.
1. Loosen (do not remove) the hex washer head screws and
insert the neutral (white) wire under the screw clamp at the
bottom of the center position terminal connector.
D
F
G
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Move range close to cabinet opening.
2. Remove cardboard or hardboard from under range. Gently
move range into its final position.
3. Pull drawer open to first stop position. Lift front of drawer to
clear white wheels in drawer guides. Remove drawer and set
it aside on a protected surface.
Making sure the anti-tip bracket is installed:
• Look for the anti-tip bracket securely attached to floor.
• Slide range back so rear range foot is under anti-tip
bracket.
2.
A. Line 1
B. Ground-link
C. Hex washer head screw
D. Silver-colored terminal
block screw
E. Neutral (white) wire
F. Line 2
G. UL listed conduit
connector and power
supply cable
Insert the other 2 wires (lines 1 and 2) under the other 2 screw
clamps.
A. Insert wire under screw clamp
B. Hex washer head screw
3. Securely tighten the hex washer head screws to 35 in.-Ibs
minimum torque to make a proper electrical connection.
4. Tighten the locking ring of the conduit connector.
5. Replace the terminal block cover.
If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
1. Place rack in oven. Place level on rack, first side to side; then
front to back.
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket. Use %" drive ratchet and
channel lock pliers to adjust leveling legs up or down until
range is level. Push range back into position. Check that rear
leveling leg is engaged in anti-tip bracket.
NOTE: Oven must be level for satisfactory baking conditions.
Replace the storage drawer.