Kenmore 66592172301 Installation Instructions Manual page 5

4. 7. Align anti-tip b racket holes withholes infloor. F asten a nti-tip
bracket withscrews p rovided.
5,
If countertop is not flush with cabinet opening edge, align
template with overhang.
= i
If cabinet opening is wider than specified in the "Location
Requirements" section, adjust template so range will be
centered in cabinet opening.
To mount anti-tip bracket to wood floor, drill two 1/8"(3.2 mm)
holes at the positions marked on the bracket template.
Remove template from floor.
Depending on the thickness of your flooring, longer screws
may be necessary to anchor the bracket to the subfloor.
Longer screws are available from your local hardware store.
8. Move range close to opening. Remove shipping base,
cardboard or hardboard from under range.
9. Connect power supply cord as described in the "Electrical
Connection" section.
10. Move range into final position making sure rear leveling leg
slides into anti-tip bracket.
6,
To mount anti-tip bracket to concrete or ceramic floor, use a
3_6" (4.8 mm) masonry drill bit to drill 2 holes at the positions
marked on the bracket template. Remove template from floor.
Tap plastic anchors into holes with a hammer.
11. Continue installing your range using the following installation
instructions.