Advertisement
Available languages
Available languages
When a 4-wire receptacle ofNEMA Type 14-50R isused, a
matching ULlisted, 4-wire, 250-volt, 50-amp, range power
supply c ord(pigtail) must b eused. T his cord contains 4 copper
conductors withring terminals oropen-end spade terminals with
upturned ends, terminating inaNEMA Type 14-50R plug onthe
supply e nd.
The fourth (grounding)
conductor must b eidentified byagreen o r
green/yellow
cover a nd theneutral conductor byawhite cover.
Cord should beType SRD orSRDT w itha ULlisted strain relief
andbeatleast 4 ft (1.22 m)long.
If connecting
to a 3-wire system:
Local codes may permit the use of a UL listed, 3-wire,
250-volt, 50-amp range power supply cord (pigtail). This cord
contains 3 copper conductors
with ring terminals or open-end
spade terminals with upturned ends, terminating
in a NEMA Type
10-50P plug on the supply end. Connectors on the appliance end
must be provided at the point the power supply cord enters the
appliance. This uses a 3-wire receptacle of NEMA Type 10-50R.
3-wire receptacle (10-50R)
4-wire receptacle (14-50R)
INSTALLATION INSTRUCTIONS
1. Remove shipping materials, tape and protective film from
range. Remove oven racks and parts package from inside
oven.
2. Do not remove the shipping base at this time.
3=
A. Shipping base
Remove storage drawer. Use a %" drive ratchet to lower rear
leveling legs one-half turn. Use channel lock pliers to lower
front leveling legs one-half turn.
A
D
""
C
'B Si'
A. _" drive ratchet
B. Rear leveling leg
C. Channel lock pliers
D. Front leveling leg
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip
bracket to rear range foot.
Reconnect
the anti=tip bracket,
if the range is moved.
Failure to follow these instructions can resumt in death
or serious burns to children
and adumts.
Contact a qualified floor covering installer for the best procedure
for drilling mounting holes through your type of floor covering.
Before moving range, slide range onto shipping base, cardboard
or hardboard.
1. Remove template from the anti-tip bracket kit (found inside
the oven cavity) or from the back of this manual.
2. Place template on the floor in cabinet opening so that the left
edge is against cabinet and top edge is against rear wall,
molding or cabinet.
3. Tape template into place.
Advertisement
