Kenmore 66592172301 Installation Instructions Manual page 6

Power Supply Cord Direct Wire
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 50 amp power supply cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Electrical Shock Hazard
Disconnect power before servicing.
Use 6 gauge copper or 4 gauge aluminum wire.
Electrically ground range.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1=
2.
3=
Disconnect power.
Remove the terminal block cover screws located on the back
of the range. Pull cover down and toward you to remove
cover from range.
S
A. Two mounting tabs each side
B. Terminal block cover
C. Hex-head screws
Complete installation following instructions for your type of
electrical connection:
4-wire (recommended)
3-wire (if 4-wire is not available)
Electrical Connection Options
If your home has: And you will be Go to Section:
connecting to:
4-wire receptacle A UL listed, 4-wire connection:
(NEMA type 14-50R) 250-volt Power supply
minimum, cord
50-amp, range
power supply
cord
4-wire direct A fused 4-wire connection:
disconnect or Direct wire
circuit breaker
(12.7 cm)
box
3-wire receptacle
(NEMA type 10-50R)
A UL listed, 3-wire connection:
250-volt Power supply
minimum, cord
50-amp, range
power supply
cord
3-wire direct A fused 3-wire connection:
v. disconnect or Direct wire
(__ circuit breaker
box