Section II Operating Instructions
5.9.3.4. AUTOMATIC GROUP CALIBRATION OF THE ANALOG OUTPUTS
I
MPORTANT
96
Teledyne API T802 Paramagnetic O
Manual calibration should be used for any analog output set for a
0.1V output range or in cases where the outputs must be closely
matched to the characteristics of the recording device.
Before performing this procedure, ensure that the AUTO CAL for
each analog output is enabled. (See Section 5.9.3.3)).
To
calibrate
the
CALIBRATION command, select the ANALOG I/O CONFIGURATION
submenu (see Section 5.9.3) then press:
I
R
MPACT ON
EADINGS OR
outputs
as
a
Analyzer Operation Manual
2
D
ATA
group
with
the
07275B DCN6418
AOUTS