Appendix A-3: Warnings And Test Measurements, Software Versions 1.0.3 (T-Series)/A.3 (E-Series) - Teledyne T802 Operation Manual

Models T802, 802E Appendix A Menu Trees (Reference: 06530C DCN6418)

APPENDIX A-3: Warnings and Test Measurements, Software Versions 1.0.3 (T-Series)/A.3 (E-Series)

1
Name
WSYSRES
WDATAINIT
WCONFIGINIT
3
WO2ALARM1
3
WO2ALARM2
2
WCO2ALARM1
2
WCO2ALARM2
WSAMPFLOW
WSAMPPRESS
WBOXTEMP
3
WO2CELLTEMP
2
WCO2CELLTEMP
WDYNZERO
WDYNSPAN
WREARBOARD
WRELAYBOARD
WFRONTPANEL
WANALOGCAL
1
The name is used to request a message via the RS-232 interface, as in "T BOXTEMP".
2
T-Series/E-Series: 801, 803 or 802 with CO
3
T-Series/E-Series: 802 or 803.
4
T-Series/E-Series: 801 or 803.
5
T-Series/E-Series: 802 only.
6
T-Series/E-Series: 803 only.
7
T-Series/E-Series: 802 with CO
8
T-Series/E-Series: 801 or 802 without CO
10
External analog input option.
Error! Unknown document property name.Error! Unknown document property name.
07275B DCN6418
Table A-2: Warning Messages
Message Text
Warnings
SYSTEM RESET
DATA INITIALIZED
CONFIG INITIALIZED
O2 ALARM 1 WARN
O2 ALARM 2 WARN
CO2 ALARM 1 WARN
CO2 ALARM 2 WARN
SAMPLE FLOW WARN
SAMPLE PRESS WARN
BOX TEMP WARNING
O2 CELL TEMP WARN
CO2 CELL TEMP WARN
CANNOT DYN ZERO
CANNOT DYN SPAN
REAR BOARD NOT DET
RELAY BOARD WARN
FRONT PANEL WARN
ANALOG CAL WARNING
option.
2
option.
2
option.
2
Description
Instrument was power-cycled or the CPU
was reset.
Data storage was erased.
Configuration storage was reset to factory
configuration or erased.
O concentration alarm limit #1 exceeded
2
O concentration alarm limit #2 exceeded
2
CO concentration alarm limit #1
2
exceeded
CO concentration alarm limit #2
2
exceeded
Sample flow outside of warning limits
specified by SAMP_FLOW_SET variable.
Sample pressure outside of warning limits
specified by SAMP_PRESS_SET
variable.
Chassis temperature outside of warning
limits specified by BOX_SET variable.
O sensor cell temperature outside of
2
warning limits specified by O2_CELL_SET
variable.
CO sensor cell temperature outside of
2
warning limits specified by
CO2_CELL_SET variable.
Contact closure zero calibration failed
while DYN_ZERO was set to ON.
Contact closure span calibration failed
while DYN_SPAN was set to ON.
Rear board was not detected during
power up.
Firmware is unable to communicate with
the relay board.
Firmware is unable to communicate with
the front panel.
The A/D or at least one D/A channel has
not been calibrated.
Appendix A
A-17