The Status Light 11 - Excalibur AL-1850-EDPB Operation Manual

The status lights, located in the window-mount antenna, provide a visual indication
of the system's status via GREEN (remote start status) and RED (alarm status) lights.
SECURiTy SySTEm STATUS (RED LiGhT):
OFF: The alarm is disarmed and not performing any automatic functions.
On COnSTAnT: The alarm is in valet mode
FLAShinG SLOW: The alarm is armed and monitoring all entry points
FLAShinG FAST: One of the automatic arming features is in progress.
AUTOmATiC TRAnSmiTTER VERiFiCATiOn (RED LiGhT):
Every time you turn on the ignition key, the status light will flash a number of times
equal to the number of controllers/transmitters programmed to the system. This
unique security feature protects you from a potential thief (valet attendant, mechanic,
installer, etc.) from adding their own transmitter without your knowledge and access-
ing your vehicle and it's contents at a later time (the perfect crime!).
ZOnE ViOLATiOn RECALL:
If the security system is triggered, upon disarming, the RED status lights will flash
a number of times to indicate exactly which zone(s), has been violated. It will store
the last 2 violated circuits and continually repeat the flash pattern until the system is
disarmed and the vehicle's ignition key is turned On
2 FLAShES: hood trigger
3 FLAShES: Door trigger
4 FLAShES: Sensor port trigger
REmOTE START STATUS (GREEn LiGhT):
OFF: The remote start is off and in standby mode.
On COnSTAnT: The remote start is in valet mode
FLAShinG SLOW: The engine was started successfully and is running.
FLAShinG FAST: The remote start sequence has begun and is in process of starting
the vehicle's engine
REmOTE START DiAGnOSTiCS (GREEn LiGhT):
The remote start system can also indicate which zone caused the last remote
start cycle was ended To see this indicator, place the system into alarm valet mode
Immediately after the chirp, the GREEN status light will flash to indicate what caused
remote start to end
1 FLASh: Run time expired
2 FLAShES: Brake pedal was pressed
3 FLAShES: Engine stalled or a bad tach signal
4 FLAShES: Received transmitter command to stop
5 FLAShES: Gear selector was moved from park(or the parking brake was released).
6 FLAShES: The alarm was triggered or low battery voltage
COmBinATiOn inDiCATiOnS:
This indication reflect combinations of functions involving the security system AND
remote start
SLOWLy ALTERnATES GREEn/RED: System is in full valet mode.
The Status Light
11