Valet Modes; Securecode - Excalibur AL-1850-EDPB Operation Manual

Using The Valet Switch (cont'd)

VALET mODES

ALARm VALET mODE, while active, completely disables all security functions.
Keyless entry and remote start are still operable. To enter valet mode, perform the
following steps:
STEP 1 - Disarm the system either with the controller or by performing an emergency
override (make sure not to hold the brake pedal)
STEP 2 - Press and hold the valet switch (located in the window-mount antenna)
for 2 seconds. The system will chirp once and the RED status light will turn on. The
controller will reflect that the system is in alarm valet mode.
REmOTE START VALET mODE, while active, disables remote start Keyless entry
and alarm functions are still operable. To enter remote start valet mode, perform the
following steps:
STEP 1 - Disarm the system either with the controller or by performing an emergency
override and hold the brake pedal
STEP 2 - Press and hold the valet switch (located in the window-mount antenna) for
2 seconds The system will chirp once and the gREEn status light will turn on The
controller will not reflect remote start valet mode.
FULL VALET mODE combines both alarm & remote start valet modes To acti-
vated full valet mode, follow these steps:
STEP 1 - Enter remote start valet You will hear a chirp
STEP 2 - Release the brake pedal but continue holding the valet switch. After 2 sec-
onds, you will hear a second chirp
STEP 3 - Immediately release the valet switch The status light will alternate between
RED and gREEn every second
EXiTinG VALET mODES is as simple as just pressing and releasing the valet
switch once. The status light will turn off. This procedure is the same for all forms of
valet mode

SECURECODE

SecureCode allows you to customize the number of valet presses required to per-
form an emergency override. This is an extra layer of security that prevents anyone
from overriding the alarm even if they have a key to the vehicle. SecureCode has 2
stages with the first requiring 1-9 button valet presses and the second requiring 0-9
valet button presses This gives you 99 possible combinations To program a custom
SecureCode, please refer to user feature #1.
To perform an emergency override with SecureCode, use the following steps:
STEP 1 - With the system armed, enter the vehicle (the alarm will activate)
STEP 2 - Turn the ignition switch to the "On" position
STEP 3 - Within 5 seconds of step 2, press the valet switch to enter the first digit of
your programmed code
STEP 4 - After a few seconds, the siren will stop sounding and chirp once (confirming
stage 1) The siren will then continue sounding
STEP 5 - Now, within 5 seconds of step 4, press the valet switch to enter the second
digit of your code. If the code is correct, the alarm will disarm.
If the code is entered incorrectly, you must turn the ignition key OFF, then back ON
to try again Additionally, if 2 failed attempts are made, the alarm will ignore any
further attempts for 2 minutes.
10