Table of Contents
Advertisement
The engine will run for the preset run time (see user feature #17).
•
Run Time Extender
restart the engine run timer The timer will restart at "0:00"
nOTE: This can only be used once per remote start cycle. The controller will also give you
"run time expiration" warning (2 chirps) 1 minute before the remote start cycle ends.
•
If you decide not to drive your vehicle, you can turn off the remote start using
the same method to turn it on (Default = press "
nOTE: if user feature #17 is programmed for 1 press, the 1st press = Run Time Extender so
an additional press is required.
•
Upon entering the vehicle during remote start mode, turn the ignition key to
the "On/RUn" position (nOT START!!) When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over.
ChAnnEL 3: Press and hold the "TRUNK" & "
seconds
ChAnnEL 4: Press and hold the "LOCK" & "TRUNK" buttons for 3
seconds
ChAnnEL 5: Press and hold the "UNLOCK" & " " buttons for 3
seconds
Controller & Transmitter Functions (cont'd)
*
: Press the "
" button one time during remote start to
•
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 3
OUTPUT
•
UPOn RECEIVIng COnFIRMATIOn FROM YOUR
SYSTEM, ThE COnTROLLER WILL ShOW ThE ChAn-
nEL 3 ICOn
(1-way transmitter: press anD holD the "||" & "|||"
buttons for 3 seConDs)
•
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 4
OUTPUT
•
ThERE IS nO 2-WAY COnFIRMATIOn FOR ThIS
FUnCTIOn
(1-way transmitter: press anD holD the loCk &
"||" buttons for 3 seConDs)
•
YOUR SYSTEM WILL ACTIVATE ThE ChAnnEL 5
OUTPUT
•
ThERE IS nO 2-WAY COnFIRMATIOn FOR ThIS
FUnCTIOn
(1-way transmitter: press anD holD the un-
loCk & "|||" buttons for 3 seConDs)
*
" twice in 5 seconds)
*
" buttons for 3
*
5
Hide quick links:
Advertisement
Table of Contents
