Table of Contents
Advertisement
The Status Light
The status lights, located in the window-mount antenna, provide a visual indication
of the system's status.
SEcuRiTy SySTEm STATuS (must be enabled by installer)
OFF: The alarm is disarmed and not performing any automatic functions.
On: The alarm is in valet mode.
FLAShinG SLOw: The alarm is armed and monitoring all entry points.
FLAShinG FAST: One of the automatic arming features is in progress.
AuTOmATic TRAnSmiTTER VERiFicATiOn
Every time you turn on the ignition key, the status light will flash a number of times
equal to the number of transmitters programmed to the system. This unique security
feature combats potential thieves (valet attendant, mechanic, etc.) from adding their
own transmitter without your knowledge and accessing your vehicle at a later time.
ALARm ZOnE ViOLATiOn REcALL
If the security system is triggered, upon disarming, the status lights will flash
a number of times to indicate exactly which zones, have been violated. It will
store the last 2 violated circuits and continually repeat the flash pattern until the
vehicle's ignition key is turned ON.
2 FLAShES: Hood trigger
3 FLAShES: Door trigger
4 FLAShES: Sensor port trigger
REmOTE START STATuS
FLAShinG SLOw: The engine was remote started successfully and is running.
FLAShinG FAST: The remote start sequence has begun.
2 FLAShES, PAuSE: The engine is running while the alarm is armed.
REmOTE START DiAGnOSTicS
The remote start system can also indicate which zone caused the last remote start
cycle to end. To see this indicator, place the system into valet mode. Immediately after
the chirp, the status light will flash to indicate which zone violation occured.
1 FLASh: Run time expired.
2 FLAShES: Brake pedal was pressed.
3 FLAShES: Engine stalled or a bad tach signal.
4 FLAShES: Received transmitter command to stop.
5 FLAShES: The neutral safety circuit was triggered.
6 FLAShES: The alarm was triggered or low battery voltage.
Anti-carjacking Protection
The system is equipped with two separate Anti-Carjacking protection features
(ignition, open door, or both) that are selectable via user feature #12. Once activated,
the user has 60 seconds to cancel the Anti-Carjacking protection process (described
below). If Anti-Carjacking is not cancelled, 53 seconds after being activated the siren
will begin to chirp for 7 seconds to alert the user that the system is about to enter into
an alarm condition. The Valet Switch may still be pressed once during this period to
cancel the Anti-Carjacking process.
If the Anti-Carjacking process is not cancelled before the 60 second countdown
expires, the system will enter an alarm condition, sounding the siren and flashing the
parking lights. 30 seconds after this occurs, or should the ignition be turned off in the
meantime, the starter interrupt will engage. Once the system enters the alarm
6
Advertisement
Table of Contents
