Adjusting Locking Cantilever Arm Height - Invacare Solara 3G User Manual

Adjusting Locking Cantilever Arm Height

 When removing the locknuts and washers from
the cantilever arm assembly, leave the top hex
bolt, coved washers and spacer (between
adjustment plate and cantilever arm) in place.
1. Remove the two locknuts and washers securing the cantilever arm
assembly to the back cane.
2. Remove the cantilever arm assembly with hardware from the back
cane.
3. Perform STEPS 1-4 in Installing Locking Cantilever Arms. on
page 58 to reposition the arm at the desired height.
Part No 1154295
..
Adjustment
Plate
Actuator
Bottom Hex Bolt
FIGURE 12
Adjusting Locking Cantilever Arm Height..
59
Coved Washers
Spacer
Top Hex Bolt and Coved
Cantilever
Washer
Installing Locking Cantilever Arms. -
Solara 3G/Spree 3G Wheelchair
10 ARMS
Locknuts
Washers
Back Cane
Arm