Arm Pad Replacement For Cantilever Arms; Installing/Removing T-Arms; Installing T-Arms - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

Arm Pad Replacement for Cantilever Arms

NOTE: For this procedure, refer to FIGURE 7.11.
1. Remove the mounting screws from the armrest pad.
2. Replace with NEW armrest pad.
3. Secure with existing hardware.
Desk Length Arm Pads
Cantilever
Arm Tube
Mounting
Screws
FIGURE 7.11 Arm Pad Replacement for Cantilever Arms

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 7.12.

Installing T-Arms

1. Position the T-Arm over the T-Arm
socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards
the front of the wheelchair.
2. Slide T-Arm into T-Arm socket until the
locking lever is in the slot in the T-Arm
socket and an audible "click" is heard.
3. Pull UP on T-Arm to make sure T-Arm
is locked in place.
NOTE: If the T-Arm does not slide in the T-
Arm socket as desired, adjust the T-Arm socket.
Refer to Adjusting T-Arm Sockets on page 54.
4. Adjust the T-Arm for desired height,
width and depth, if necessary. Refer to
Adjusting The T-Arms on page 52.
5. Repeat STEPS 1-4 for opposite side of
wheelchair.
Part No 1125027
Armrest Pad
Cantilever
Arm Tube
Mounting Screws
Wheelchair
T-Arm
Socket
FIGURE 7.12 Installing/Removing T-Arms
51
SECTION 7—ARMS
Full Length Arm Pads
Frame
Arm Pad
Cantilever
Slide Tube
T-Arm
Locking Lever
(towards the front
of the wheelchair)
Slot
® ™
Solara /Spree GT