Removing T-Arms; Adjusting The T-Arms; Adjusting T-Arm Height - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 7—ARMS

Removing T-Arms

1. Press the locking lever in and lift the T-Arm straight up and out of the T-Arm socket.
NOTE: If the T-Arm does not slide up and down in the T-Arm socket as desired, adjust
the T-Arm socket. Refer to Adjusting T-Arm Sockets on page 54.
2. Repeat STEP 1 for opposite side of the wheelchair.

Adjusting The T-Arms

Adjusting T-Arm Height

NOTE: For this procedure, refer to
FIGURE 7.13.
1. Unlock the T-Arm by flipping the T-
Arm release lever towards the inside of
the wheelchair.
NOTE: If necessary, pull the T-Arm release
lever out and rotate 180° so it can be flipped
towards the outside of the wheelchair.
2. Slide the T-Arm to one of:
• Low Height T-Arms - Nine
positions.
• High Height T-Arms - Seven
positions.
NOTE: If the inside T-Arm post does not
slide up and down in the outside T-Arm
post as desired, perform one of the
following:
• Tighten - Tightening the set screws
on the outside T-Arm post will
make it more difficult to move the
inside T-Arm post up and down.
• Loosen - Loosening the set screws on the outside T-Arm post will make it easier to
move the inside T-Arm post up and down.
3. Lock the T-Arm by flipping the T-Arm release lever towards the front of the
wheelchair.
® ™
Solara /Spree GT
Set Screws
Outside T- Arm Post
FIGURE 7.13 Adjusting T-Arm Height
52
T-Arm
INSIDE T-Arm Post
T-Arm Release Lever -
LOCKED Position
T-Arm Release Lever -
UNLOCKED Position
Part No 1125027