Securing The Occupant; Wheelchair-Anchored Belts - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

Securing the Occupant

Wheelchair-Anchored Belts

The pelvic belt that is provided by Invacare has been tested for use in a motor vehi-
cle on this wheelchair ONLY. DO NOT replace the pelvic belt with a different style
pelvic belt.
NOTE: For this procedure, refer to FIGURE 15.2.
The wheelchair has been provided with a pelvic belt which meets the requirements of
ANSI/RESNA WC/19.
The pelvic belt provided by Invacare has been designed to accommodate use on either
side of the vehicle. If necessary, follow the instructions below to reverse the orientation of
the pelvic belt to accommodate the vehicle-anchored upper torso belt.
1. Install the pelvic belt pin (Detail "A" of FIGURE 15.2) into slot in the pelvic belt
bracket. Pull upwards until it snaps into place.
NOTE: Note the position of the male end of the belt when installing the pelvic belt onto the pelvic
belt brackets. The male end of the pelvic belt (Detail "A" of FIGURE 15.2) has a pin which is used
to secure the vehicle-anchored upper torso belt.
2. Repeat STEP 1 for the opposite pelvic belt bracket.
3. Install the vehicle-anchored upper torso belt onto the pin on the male end of the pelvic
belt.
Male End
Pin
(Used to secure the
vehicle-anchored
upper torso belt.)
Part No 1125027
WARNING
DETAIL "A" - PELVIC BELT
Pin
Pelvic Belt
FIGURE 15.2 Wheelchair-Anchored Belts
SECTION 15—TRANSPORT READY OPTION
Slot
Pin
Tie-Down
Bracket
95
Pelvic Belt
Bracket
® ™
Solara /Spree GT