Contracture Assembly Angle Adjustment; Using The Optional Quick-Release Pin - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

Contracture Assembly Angle Adjustment

NOTE: For this procedure, refer to FIGURE 14.3.
1. Perform one of the following:
• Bilateral Contracture - Remove the mounting bolt and locknut used to lock the
angle adjustment of the contracture assembly.
• Contracture Platform - Remove the two mounting bolts and locknuts that lock the
angle adjustment of the contracture assembly.
2. Lift the contracture support up/down to achieve the desired angle.
3. Perform one of the following:
• Bilateral Contracture - Align the mounting hole in the contracture support with
one of seven mounting holes on the angle adjustment bracket.
• Contracture Platform - Align the upper support mounting hole with one of four
mounting holes in the angle adjustment plate.
4. Reinstall the mounting bolts (s) and locknut(s) to lock the angle adjustment of the
contracture assembly. Securely tighten.
Bilateral Contracture
Mounting Bolt
Locknut
Contracture
Support
FIGURE 14.3 Contracture Assembly Angle Adjustment

Using the Optional Quick-Release Pin

If not installed at time of shipment, the quick-release pin MUST be installed by a
qualified technician only, using a 1/8-inch pop rivet.
NOTE: For this procedure, refer to FIGURE 14.4 on page 88.
NOTE: This procedure applies to the bilateral contracture footplate only.
NOTE: The quick-release pin replaces the mounting screw that is used to lock the angle adjustment
of the contracture support.
Part No 1125027
SECTION 14—CONTRACTURE FOOTPLATE OPTION
Angle Adjustment
Bracket
Adjustment Plate
Mounting Holes
WARNING
87
Contracture Platform
Locknuts
Angle
Hole #
4
3
2
1
Angle
Mounting
Bolts
Upper
Support
® ™
Solara /Spree GT