Adjusting Locking Cantilever Arm Angle - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 7—ARMS
Back Cane
Adjustment Plate
Locknuts
Coved Washers
Washers
Actuator
Spacer
Top Hex Bolt and
Coved Washer
Bottom Hex Bolt
Cantilever Arm
FIGURE 7.6 Installing Locking Cantilever Arms - Adjusting Locking Cantilever Arm Height

Adjusting Locking Cantilever Arm Angle

NOTE: For this procedure, refer to FIGURE 7.7.
NOTE: This adjustment is recommended if the back angle has been changed to keep arm parallel
to the ground/floor.
1. Flip the cantilever arm up and out of the way.
2. Remove the locknut that secures the locking pin to the arm adjustment plate.
3. Determine the mounting hole in the arm adjustment plate that will be used to
correspond to the back angle (FIGURE 7.7).
4. Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5. Repeat STEPS 1-4 for the opposite side, if necessary.
47 ® ™
Part No 1125027 Solara /Spree GT